This document discusses various sources of water and methods of water purification. It describes the three main sources of water as rain, surface water, and ground water. Surface water sources include rivers, reservoirs, lakes and seas. Ground water sources include shallow wells, deep wells, and springs. The document then discusses various methods used to purify water, including storage, filtration, and disinfection. It provides details on storage, slow sand filtration, and rapid sand filtration as common purification techniques.
1. Dr. Rahul B. Pandit
Faculty of Nursing
Sassoon General Hospital, Pune
2.
3.
4.
5.
6.
7.
8. Introduction
Water to be one of four elementary substances
along with Earth, Fire and Air.
Water is a precious resource and without it life
is not possible on earth.
Water is a prime natural resource.
Water is essential for drinking, cooking,
bathing and washing, laundering, ablution,
domestic, sanitation, Agriculture and
industries.
9. Safe and wholesome water must be
Free of pathogenic organisms
Free from harmful chemical substances
Acceptable to taste and appearance
Usable for domestic purposes
10. Sources of Water
There are mainly three sources of water
1. RAIN
2. SURFACE WATER
• Impounding reservoirs
• Rivers and streams
• Tanks, ponds and lakes.
3. GROUND WATER
• Shallow wells
• Deep wells
• Springs
11. Rain
Rain is the prime source of all water.
Purest form of water
clear, bright and sparkling
No biological contamination
Soft, slightly acidic (carbonic acid)
Contaminants- from the atmosphere
Acid rain
12.
13. Surface Water
Surface water originates from rain water.
It is the main source of water supply in many
areas.
Examples of surface water include rivers, tanks,
lakes, man – made reservoirs and sea water.
Surface water is prone to contamination from
human and animal sources.
Surface water needs purification before use for
drinking and cooking purposes.
14. Impounding reservoirs
These are artificial lakes constructed usually of
earthwork in which large quantities of surface water
is stored.
Dams built across rivers and mountain streams also
provide large reserves of surface water.
The area draining into the reservoir is called
“catchment area”.
The disadvantage of storing water is the growth of
algae and other microscopic organisms, which impart
bad tastes and odors to water.
15. Impounding reservoirs
Characteristics
Impounding reservoirs usually furnish a fairly
good quality of water.
The water is usually clear, palatable and
ranks next to rain water in purity.
The water is usually soft and considered tobe
free of pathogenic organisms.
16. Impounding reservoirs
Impurities
The upland surface water derives its
impurities from the catchment area, the
sources being human habitations and animal
keepig or grazing..
17. River
Characteristics
River water is turbid during rainy season; it
may be clear in other seasons.
Clarity of water is no guarantee that river
water is safe for drinking.
It contains dissolved and suspended impurities
of all kinds.
18. River
Impurities
The impurities of river water are derived from
Surface washings
Sewage and sullage water
Industrial and trade wastes
Drainage from agricultural areas.
19. Tank
Tanks are large excavations in which surface
water is stored.
They are an important source of water supply
in some parts of the country.
Tanks are recipients of contamination of all
sorts.
They are full of silt and colloidal matter,
especially after the rains.
Older tanks may be full of aquatic vegetation.
20. Sea Water
Though this source is plentiful, it has great
many limitations.
It contains 3.5 per cent of salts in solution.
Offshore waters of the oceans and seas have a
salt concentration of 30,000 to 36,000 mg/litre
(30-36 g/litre) of dissolved solids
19,000 mg/litre of chloride, 10,600 mg/litre of
sodium and 1,270 mg/litre of magnesium.
21. Ground Water
Rain water percolating into ground water
constitutes ground water.
Ground water is the cheapest and most
practical means of providing water to small
communities.
Ground water is superior to surface water,
because the ground itself provides an effective
filtering medium.
22. Ground Water
Advantages and Disadvantages
It is likely to be free from pathogenic agents
It is usually requires no treatment.
The supply is likely to be certain even during dry
season.
It is less subject to contamination than surface
water.
It is high in mineral content.
It requires pumping or some arrangement to lift the
water.
23. Wells
Traditionally wells are the common and main
source of water supply in most areas.
Technically wells are of two
1. Shallow wells
2. Deep wells
26. Sanitary Well
This is a well that is properly located, suitably
constructed and well protected from
contamination, thus supplying safe water.
The following important points are to be taken into
consideration in constructing safe wells:
a) Location
b) Lining
c) Parapet
d) Platform
e) Drain
f) Covering
g) Hand-pump
27. Location – Should be away not less than 15m
from sources of contamination. Distant
between well and the house (<100m)
Lining – Lining should be built of bricks or
stones set in cement up to 6 m deep, to allow
the water to enter from the bottom and not
from the sides of the well. Lining should be
curried 60-90cm above the ground.
Parapet wall – A parapet wall around the well
up to the height of at least (70-75 cm) should
be provided above the ground.
28. Platform – Along with the parapet wall the platform
should be made with cement concrete extending at
least 1m in all directions. It should have gentle slope
outward leading to a drain built along its edges.
Drain – A pucca drain should be built to collect the
spilt and dirty water from the platform of the well
and this should be channeled to a drain or soak pit
that is away from the well.
Covering – The top of the well should be covered well
by a cement concrete cover to avoid direct
contamination.
Hand pump – A good sanitary well should be equipped
with a hand pump to lift the water in a clean manner.
29. Tube Well
Tube wells are successful as a source of
drinking water in many parts of India.
They yield water which is bacteriologically
safe, and are also cheap in comparison to
other sources of supply.
Shallow tube wells have become the largest
individual source of water supply to the rural
community.
30. Springs
Ground water comes to the surface and flows freely
under natural pressure
Two types
Shallow springs
Deep springs
32. Purification of Water
Water is very basic and essential element of
human life.
Source of infection.
To prevent water borne diseases needs
purification.
Water purification can be done at large scale
and small scale.
33. Purification of Water
To provide safe water to the community many
water treatment methods are used to purify
water.
There are various methods of purification of
water.
Selection of purification method depends on
nature and quality of water.
36. Storage
Storage is the natural method of purification.
Water collected from the source in the
reservoirs are treated by using storage system.
Storage means allowing water to remain for
required number of hours in natural or
artificial storage reservoirs.
Suitable time duration allowed for storage of
river water is 10-14 days.
37. Storage
More than 15 days of storage would cause bad
smell and color changes due to algae growth.
Storage reduces the impurities of water like
physical, chemical and biological.
38. Physical
Storage reduces the turbidity and give clear
appearance.
Storage allows 90% of suspended impurities to
settle down within 24 hours.
Storage improves water quality.
39. Biological
Storage reduces the pathogens presents in
water.
Storage of river water for period of 5 to 7 days
reduces the 90% of bacterial count.
41. Filtration
Filtration is the second step in water
purification.
It is the most essential step because it cause
99% reduction in bacterial count.
There are two types of filters
slow sand filter / biological filter
Rapid sand filter / Mechanical filter
42.
43. Principles of Filtration
It is a simple process.
Impure water is allowed to flow through sand
layer that provides physical and biological
treatment.
Slow sand filter use biological process.
Rapid sand filter use physical treatment.